| Část Ne | Výrobcem | Aplikace |
|---|
| MAX3222CAP | MaximIC | 3.0V to 5.5V, low-power, up to 1Mbps, true RS-232 transceiver using four 0.1microF external capacitor. Low supply current 300microA. Guaranteed data rate 120kbps. |
| MX674AJEWI | MaximIC | Industry standard complete 12-bit A/D converter. 15 microsec. max conversion time. Linearity (LSBs) 1. TEMPCO(ppm/C) 75. |
| MAX6312UK33D3-T | MaximIC | Multiple-input, programmable reset IC(push/pull reset output, factory-set reset threshold on Vcc, 1 additional undervoltage reset input, manual-reset input). Factory-trimmed reset thresholds 3.218(min) 3.383(max). Nominal timeout period 140ms. |
| MAX507ACWG | MaximIC | Voltage-output, 12-bit DAC with internal reference. 12 data-bus widths. Error +-1/2. |
| MAX850C/D | MaximIC | Low-noise, regulated, negative charge-pump power supplies for GaAsFET bias. 2mVp-p output voltage ripple. 100kHz chage-pump switching frequency. Logic-level shutdown mode 1microA max over temp. |
| MAX1110MJP | MaximIC | 2.7 V, low-power, multichannel, serial 8-bit ADC. 8-channel single-ended or 4-channel differential inputs |
| MX674ALN | MaximIC | Industry standard complete 12-bit A/D converter. 15 microsec. max conversion time. Linearity (LSBs) 1/2. TEMPCO(ppm/C) 10. |
| MAX378EWG | MaximIC | High-voltage, fault-protected analog multiplexer. |
| MAX405EPA | MaximIC | Precision video buffer amplifier. |
| MAX267BENG | MaximIC | Pin programmable univesal and bandpass filter. Accuracy 2%. |
| MAX6320PUK30CY-T | MaximIC | Microprocessor supervisory circuit with watchdog and manual reset (watchdog input,manual reset input, reset output active-low, open-drain).Factory-trimmed reset threshold(typ) 3.000V, reset timeout(min) 140ms, watchdog timeout(typ) 1.6sec |
| MAX6318MHUK36DW-T | MaximIC | Microprocessor supervisory circuit with watchdog input (watchdog input,reset output active-high,push/pull and active-low, bidirectional).Factory-trimmed reset threshold(typ) 3.600V, reset timeout(min) 1.12sec, watchdog timeout(typ) 6.3ms |
| MAX333ACWP | MaximIC | Precision, quad, SPDT, CMOS analog switch. |
| MAX6319LHUK27D-T | MaximIC | Microprocessor supervisory circuit with manual reset (manual reset input, reset outputs active-low,push/pull and active-high, push/pull).Factory-trimmed reset threshold(typ) 2.700V, reset timeout(min) 1120ms |
| ICL8069ACSQ2 | MaximIC | Low-voltage reference, 10 ppm/C - max temp. coefficient. |
| MAX6318MHUK50BW-T | MaximIC | Microprocessor supervisory circuit with watchdog input (watchdog input,reset output active-high,push/pull and active-low, bidirectional).Factory-trimmed reset threshold(typ) 5.000V, reset timeout(min) 20ms, watchdog timeout(typ) 6.3ms |
| MAX4614ESD | MaximIC | Low-woltage, high-speed, quad, SPST, CMOS analog switch has four NO switches. |
| MAX4111CSA | MaximIC | SPST, single-input, single-output switch. 330MHz -3dB bandwidth. |
| MAX6316MUK39CW-T | MaximIC | Microprocessor supervisory circuit with watchdog and manual reset (watchdog input,manual reset input,reset output active-low,bidirectional).Factory-trimmed reset threshold (typ) 3.900V, min reset timeout 140ms, typ watchdog timeout 6.3ms |
| MAX821LUS-T | MaximIC | Microprocessor voltage monitor with pin-selectable power-on reset timeout delay (1ms,max, 20ms,min or 100ms,min). Reset threshold(nom) 4.63V. Active-low reset output. |
| MAX6307UK37D2-T | MaximIC | Multiple-input, programmable reset IC (open-drain reset output,factory-set reset threshold on Vcc,1additional undervoltage reset input,negative/overvoltage reset inp.).Factory-trimmed reset thresholds3.608(min),3.793(max).Nominal timeout period 20ms. |
| MAX6317HUK39BX-T | MaximIC | Microprocessor supervisory circuit with watchdog and manual reset (watchdog input,manual reset input,reset output active-high, push/pull).Factory-trimmed reset threshold (typ) 3.900V, min reset timeout 20ms, typ watchdog timeout 102ms |
| MAX4175CAEUK-T | MaximIC | Single, Rail-to-Rail, GainAmp op amp with precision internal gain-setting resistors. Rf/Rg inverting gain 100, 1+ (Rf/Dg) noninverting gain 101, -3dB BW 230kHz. |
| MXD1013UA010 | MaximIC | 3-in-1 silicon delay line. Output delay 10ns. |
| MX7225LN | MaximIC | CMOS quad 8-bit D/A converter with double-buffered logic inputs. Error +-1 LSB. |
| MAX6318MHUK46BZ-T | MaximIC | Microprocessor supervisory circuit with watchdog input (watchdog input,reset output active-high,push/pull and active-low, bidirectional).Factory-trimmed reset threshold(typ) 4.630V, reset timeout(min) 20ms, watchdog timeout(typ) 25.6sec |
| MAX384EPN | MaximIC | Low-voltage, dual 4-channel multiplexer with latchable inputs. |
| MAX230EJP | MaximIC | +5V-powered, multichannel RS-232 driver-receiver. |
| MAX6312UK45D4-T | MaximIC | Multiple-input, programmable reset IC(push/pull reset output, factory-set reset threshold on Vcc, 1 additional undervoltage reset input, manual-reset input). Factory-trimmed reset thresholds 4.388(min) 4.613(max). Nominal timeout period 1120ms. |
| MAX293EWE | MaximIC | 8th-order, lowpass, elliptic, switched-capacitor filter. Clock-tunable corner-freguency range 0.1Hz to 25kHz |
